3
AR715 / AR715C
1
7
Plastic base Ø380
AR715 / AR715C
1
9
Filter Ø430
AR715 / AR715C
1
11
TOP selector valve
AR715 / AR715C
1
12
Hose connection of Ø38 x 580
AR715 / AR715C
1
14
Pump 3/4cv
AR715 / AR715C
14
1
Pipe cup
AR715 / AR715C
14
2
Nut Ø 2 1/4"
AR715 / AR715C
14
3
Discharge sleeve Ø38
AR715 / AR715C
14
4
O-Ring
Pressure gauge, hoses conections pool, skimmer and sand NO SUPPLIED
in the models AR700 / AR7050 / AR710 / AR715
1.1 REQUIREMENTS FOR CORRECT INSTALLATION
This apparatus is easy to install and can be assembled by
ONE ADULT
in about
2 HOURS,
taking care to correctly follow
the instructions detailed in this manual.
Only the following tools are required to correctly handle the filter components and to install it.
Task Tool
Alternative
tool
Tighten the hose flanges
7mm Stecker screwdriver
Philips screwdriver
Cut the liner
Cutter
Knife
Protection of collector pipe
Piece of plastic
Piece of fabric
2 BEFORE CONNECTING THE FILTER
Location
Place the filter on a flat, solid surface at a minimum distance of 3.5 metres from the pool ,
Fig. 2
(in accordance with
standard NF C15-100 or the equivalent standard of the region or country) and at the same level as the bottom of the pool
to prevent air from entering the cleansing circuit and the filter from becoming unprimed. The filter should be protected
from sun and rain, and kept it in an area with sufficient ventilation during operation. Never cover it during operation.
Assembly
After the filter has been set into place, proceed as follows:
You will find instruction sheets with the equipment which show you the steps to follow when starting to assemble the
equipment
•
Place the inner collector properly on the bottom of the filter
(Fig. 6).
•
Insert inside the filter 25 Kg of sand for AR700 and AR7050. Insert inside the filter 40 Kg of sand for AR710 and 70 Kg
of sand for AR715. The silica sand lasts for an unlimited period of time and should only be replaced in the event of
sand loss. Record the sand level for future replacement. Keep the remaining sand in the bag in a dry place. (
Fig.5)
•
Eliminate the remains of sand from the filter opening and remove the protective plastic.
•
Place the TOP selector valve with its coupling and secure with the plastic band or seal following the diagrams in the
instructions attached to the metal plastic.
•
Tighten firmly the screw on the plastic band (
Fig.4
), which joins the valve to the filter.
•
Cover the opening of the inner collector tube with protective plastic in order to prevent sand from entering the tube.
•
Connect the suction and discharge hoses to the suction and discharge terminals on the valve, tightening them firmly
with the clamps (
Fig.9, Fig.12)
.
•
Insert the Teflon supplied on the thread of the skimmer terminal and connect the other end of the suction hose.
Tighten firmly with a clamp. Repeat the same procedure with the feedback nozzle terminal and connect the discharge
hose.
•
Following installation, the first cycle of filter backwash should be performed. In order to do so, follow the instructions in
the section 5.3.
3 ELECTRIC CONNECTION
All electrical installations should comply with the following standard:
NF C15-100
NF EN 60-335-2-41
that refers “to the construction of electrical installations, both in indoor and outdoor swimming pools”, or the
equivalent standard in force in each region or country.
