San Telequip (P) Ltd.,
504 & 505,Deron heights,Opp Mahabaleshwar hotel
Baner Road,Baner Pune 411 045
Phone : 020-, 65001587
Connecting. Converting. Leading !
email :
info@santelequip.com
.
30
6.3.1.2 Firmware Files:
The Gateway Firmware contains the application program commonly referred to as the DCC or
the PCC. This program contains the protocol drivers applicable to the application and the
FieldServer Operating System Kernel.
A Firmware update is only required when updated files are received from service support.
Firmware files have a .bin extension.
6.3.1.3 General (Other) Files:
Other files can be updated, the procedure for updating these is the same as for configuration
files, but the update needs to be made in the “General” update section.
6.3.2 Network Settings
On the Network Settings Page, the Ethernet adaptor settings of the Gateway can be changed.
The N1 and N2 (if supported) adaptor IP address, Netmask, and default Gateway can be
changed by entering values in the applicable fields and clicking on the Update IP settings
Button.
NOTE: The Gateway has to be restarted for any changed settings to take effect. Also note
that enabling the DHCP client on any adaptor will cause the static IP address settings to be
overruled by a DHCP server on the network.
The Gateway’s built-in DHCP server can be enabled to establish easy connection for Support
purposes. Set the laptop or computer to automatically obtain an IP address to use this feature.
Note that the FieldServer DHCP server periodically checks for other DHCP servers on the
network and will disable itself should any other DHCP servers exist on the network. This mode
of operation is because the Gateway DHCP server is strictly for support purposes and does
not have all the features of a commercial DHCP server. Setting the default gateway IP
address to your network gateway will ensure the BMS converter is reachable on the internet.