San Telequip Private Limited.,
504/505 Deron Heights, Baner Road, Baner
Pune 411045, Mah, India
Phone: +91-20-27293455,9764027070,8390069393 Connecting. Converting. Leading!
email:
_______________________________________________
Page 33 of 65,
5. Advanced Settings
5.1 SNMP Settings
SNMP Settings determines whether your device settings can be viewed with standard SNMP software;
by default it is disabled.
SysName
which is by default the MAC address
SysLocation
refers to the device’s physical location.
SysContact
is the device administrator’s contact information.
If you wish to make the information available for public viewing by a Read Community, simply check the
“Enable SNMP”
box and fill in
“Public_viewers”
in
Read Community
field. If you wish to allow a
group of people called
“Power_users”
to change the information, enter
“Power_users”
in
Write
Community.
If you allow a trap server to collect device information, please fill in
SNMP Trap Server
with its corresponding IP address (the trap server designed to collect all alarm information).
Configuration will take effect after the device is restarted.
You will have to load a MIB Browser on a PC to see the Traps generated The IP address of this PC
should be entered as SNMP Trap server in the below screen.
Select Receive Traps in the MIB Browser.
Fig. 3. 14
