GS-818 GPS/GSM/GPRS Vehicle Tracker User Manual
31 Copyright © 2011 San Jose Technology, Inc. All Rights Reserved.
Set up Auto Report by Stationary Times
The GPS(GPRMC) data can report to server or cellular phone automatically during a period of time or during a distance of
travel or by stationary(vehicle stop/park status) times.
Use this command to set up the stationary detection times of Auto Report, the device will report 2 types of Auto Reports:
Distance Auto Reports and Stationary Auto Reports. If you send the SMS command as the following example, the device
will check the distance traveled every 5 minutes when vehicle is moving, and check the stationary status every 5 minutes
(300 seconds) when vehicle is stopped. The device will send Auto Report if the device detected continuously 10 times
stationary status, so the actual Auto Report interval will be 5 minutes x 10 =50 minutes (it means the device will send
stationary Auto Report every 50 minutes). the device will not send report if the device detected stationary status fewer
than 10 times or non-continuity 10 times stationary status. The total number of reports times is 99.
Setup format:#
「
User Name
」
,
「
Password
」
,
「
Function Code
」
,
「
Intervals (sec)
」
,
「
Total number of reports
」
,
「
Distance
Interval(m)
」
,
「
stationary Detection(times)
」
*
Example1
：
#username,0000,6,300,99,100,10*
Table: Auto Report by Stationary Setup Format Description
SMS Text
Description
#
Start sign.
username
Default user name of the device.
If you have changed the username, please use the updated one.
0000
Default password.
If you have changed the password, please use the updated one.
6
Mode 6 defines Auto Report setup mode.
300
Time Interval (period) of Auto Report.
99
Times (frequency) of Auto Reports that will be sent automatically.
100
Distance Interval: when the auto report function is activated, the tracker will take the
current position as the start. If this value is defined, when the tracker exceeds the distance
traveled during a time of period, the alarm report will be sent to the assigned route. The unit
of this function is meter. The minimum distance setting is 100m.
10
Stationary Detection: If this value is defined by 5, the tracker will detect if the tracker
exceeds the circle for 5 times. If the tracker doesn’t exceed this circle, the tracker will send
a notice command. The unit is times.
*
End sign.
