11F., No.2, Sec. 4, Jhongyang Rd., Tucheng Dist., New Taipei City 236, Taiwan (R.O.C.)
Tel: 886-2-22694456
｜
Fax: 886-2-22694451
｜
sanav@sanav.com
11
©
S
an
Jo
se
T
ec
hno
lo
gy
, I
nc
.
A
ll sp
eci
fica
tion
s su
bje
ct
t
o ch
an
ge
w
ith
ou
t n
ot
ice
.
www.sanav.com
www.sanav.com
Command Setup for MU-201 S2
MU-201 S2 currently provides SMS command and COTA (TCP) command for remote setup. User can setup the
MU-201 S2 by following the instructions shown in following chapters via SMS/COTA. Key the specific SMS
message in your cellular phone and send it to the SIM number of MU-201 S2. The setup messages are showed
in the following sections.
1: The default setting:
Default ID is “MU201S2”. Please read chapter Change User Name to desired ID.
Default password is “0000”. Please read chapter Change Password to change the password.
There is no number in the default contact. Please read chapter Set up Phone Book List to add the number.
Default setting of
Retrospective Location Mode
is deactivated. Please read chapter Set up Retrospective
Location Mode by Time to setup the regular Retrospective Location Mode.
Default setting of APN is only suitable for Taiwan 3G network. Please read chapter Set up APN for 3G Service
to change the APN.
Default setting of URL is http://track.sanav.com/eric-gga/gprs.aspx. Please read chapter Set up URL to
change the URL for http server setup.
Before doing any setup, please ensure the device is connected with the 3G network. The GSM LED must light
on. And please note the device is not in SOS/Panic mode.
2: Please note that all the characters which include #, * and comma (,) should be HALFWIDTH form.
3: Please be aware of the upper (capital)/lower cases when entering the SMS command.
4: While entering any SMS command, note that NO SPACE is allowed between the characters, comma and
signs in the SMS.
5: Any setup command must be started with a “#” sign and ended up with a “*” sign.
6: The comma (,) can be abbreviated if no further setup required for the command besides Set up APN for 3G
Service. Please refer to the examples of Set up Retrospective Location Mode.
7: Add or not add the “+ “sign in front of the cellular phone number(s) are both acceptable, while the”+” sign
should precede the international call prefixes. The specified international call prefix is required if “+ “sign is not
added.
8: The device will update setting Only when the password, MU201S2 and setup command are all correct.
If the command is not valid, a failure report is going to be sent to the user’s cell phone.
9: Some PREPAID PHONE CARD SIM modules do not enable or even support 3G service. Please consult with 3G
carrier for further information.
2019.09.11
新禾航電
文管中心
