19
How to Operate the Robot
1. Turn On\Off
Press the power switch at the bottom of the robot to turn on or turn off the power.
2. System load
It takes about 2 minutes to perform self-test,navigation start,position calibration and other services.If there is a map on the robot, it asks you to select the current position
on the map as the initial position, else it skips this step;
Note: 1.When selecting the initial position point, please confirm whether the robot's position and Angle are correct before clicking "ok".It is suggested that the deviation
between the initial point you choose and the actual position of the robot should not be more than 0.5 meters, and the deviation of angle should not be more than 15°.Therefore,
you can make a mark on the common initial position, such as sticking an arrow on the floor or ceiling to indicate the position and direction, so that different people can choose
the correct position and direction of the initial position of the robot.
2.If the deviation exceeds the allowable range, it can be adjusted by manually pushing the robot before clicking "ok". If "ok" has been clicked, you need to restart the
Power switch
Summary of Contents for MAX
