33
Reconnect the negative terminal on the battery. Inspect your
installation, make sure the kit is properly positioned and all fasteners
are secure. Keep all stock parts in case you ever need to reinstall
the stock intake assembly. Affix the ID label near the intake kit. The
installation is now complete.
Tool Required:
10mm Socket/Wrench
SBFILTERS.COM
Place the Air Filter
(S)
into the Air Box
(A)
. Rotate the air
filter into position as shown below and tighten the #80
Hose Clamp
(X)
.
Tool Required:
8mm Socket/Wrench
28
Press the Lid Seal
(W)
into the groove in the Air Box
(A)
.
29
Remove the protective covering on the Clear Lid
(V)
.
30
32
Reconnect the MAF sensor harness into the MAF sensor
and engage the red locking clip.
Install the Clear Lid
(V)
onto the Air Box
(A)
with the 10-24
Screws
(U)
and Lid Washers
(T).
Tool Required:
Phillips Screwdriver
31
10