SBFILTERS.COM
SENSOR
MAF PLATE
MAF GASKET
TIGHTEN HOSE CLAMP
24
Carefully remove the MAF sensor from the stock intake tube. Use the supplied 8-32 Screws
(K)
, MAF Plate
(M)
, MAF Gasket
(L)
to
install the sensor onto the Intake Tube
(E)
. Install the Vacuum Hose Barb
(J)
until finger tight, then turn it one to two complete turns
with a wrench. Do not over tighten.
Tool Required:
Adjustable Wrench, 8mm Socket/Wrench, Screwdriver
26
25
Install the Coupler
(F)
and two #52 Hose Clamps
(G)
onto
the intake tube. Leave both hose clamps loose, push
coupler up the tube slightly.
Place the Air Filter
(C)
into the Intake Box
(A)
. by first
having the filter top facing the front of the vehicle then
sliding it in, then turn the filter to the tube outlet. The
air filter should be in the same position as shown below
when inserting into the intake box.
27
Insert the Intake Tube
(E)
through the Tube Seal
(D)
into the
Intake Box
(A)
then slide the Air Filter
(C)
onto the intake
tube. Tighten the #80 Hose Clamp
(H).
Tool Required:
8mm Socket/Wrench
CONNECT
CONNECT
28
Remove the stock vacuum hose and use the Vacuum Hose
(N)
provided to connect the Vacuum Hose Barb
(J)
and the
engine.
10
