#56
#52
Install the Tube Seal
(D)
onto the Air Box
(A)
.
7
Determine if you want to install the Box Plug
(S)
onto the Air
Box
(A)
or leave it open. See the “Air Box Plug” note on Page 2
for more information. If the Box Plug is desired, simply press
the Box Plug into the box opening until it snaps into place.
8
Carefully remove the MAF sensor from the stock intake tube
then install the sensor onto the Intake Tube
(C)
with the 8-32
Screws
(M)
, MAF Plate
(H)
and MAF Gasket
(G)
. Install the Filter
Minder Grommet
(J)
into the intake tube.
Tool Required:
T20 Torx, Screwdriver
9
11
Install the Intake Tube
(C)
into the Air Box
(A)
then install the intake assembly into the truck. Align the fender side opening of the
airbox with the inlet, then rock the airbox downward. Push down on the box to make sure that the air box is completely seated on
the grommets then slide the coupler onto the turbo inlet.
Slide the Coupler
(F)
and #56 and #52 Hose Clamps
(P & N)
onto the Intake Tube
(C)
. Make sure the coupler is seated
up to the stop bead. Tighten the #56 hose clamp only, leave
the #52 hose clamp loose.
Tool Required:
5/16” Nut Driver or Flat Blade Screw Driver.
10
6
