Lawn Mower
Handlebars
F
F
E
E
D
Valco
Holes
Valco
Holes
Valco Pins
Valco Pins
Step 5
Step 5
:
Attach Hitch Tube and
Corner Tubes to Vertical
Mount System.
Attach Hitch Tube (D) to Corner
Tubes (E) by pressing down on
Valco Pins and locking into place as
outlined in diagram above. Set width
of U-bar assembly (D&E assembled)
to coincide with the width of Vertical
Bar assembly.
Attach U-bar (D&E assembled) to
Vertical Tubes (F) by simply pressing
down on Valco Pins and locking into
place. Make certain Hitch is centered
to lawn mower.
User Tip!
When setting width of U-bar assembly, make certain that
Valco Pins are consistent on each side. For example, if Valco Pin is
coming through on hole 2 on left-hand side then Valco Pin should be set
for hole 2 on right-hand side. Doing so will ensure hitch is centered with
lawn mower.
3"-4"
Step 6
Step 6: Setting Angle and Height.
Swing assembly AS CLOSE to mower as possible without hitting
mower or impeding the mower bagging system*. Make certain left
Clamp and right Clamp angles are the same. Once proper angle
is achieved, FULLY TIGHTEN ALL SCREWS (6 total) with
Phillips screwdriver.
Set height of assembly, via Valco Pins, to NO LESS than 3 inches off
the ground. Make certain that heights are the same on left-hand side
and right-hand side.
Place protective vinyl caps (included) on threads of 2" Phillips Pan
Head Head Screws (I). Vinyl cap placement is ONLY necessary when
clamp system is attached to 7/8" handlebars. Vinyl cap placement
protects screw threads from brushing up against bagging system*.
*Bagging system not supplied with all mowers.
IMPORTANT:
Assembly must not be hitting the ground – a minimum
of 3 inches of clearance is needed for proper performance. Set height
adjustment to accommodate.
10
11
