S&C Instruction Sheet 1025-510 3
Introduction
Special Warranty
Provisions
The standard warranty contained in the seller’s standard conditions of sale, as set forth
in Price Sheet 150, applies to GridMaster Microgrid Control System, except that the first
paragraph of said warranty is replaced by the following:
(1) General:
The seller warrants to the immediate purchaser or end user for a period
of 10 years from the date of shipment that the equipment delivered will be of the
kind and quality specified in the contract description and will be free of defects of
workmanship and material. Should any failure to conform to this warranty appear
under proper and normal use within 10 years after the date of shipment the seller
agrees, upon prompt notification thereof and confirmation that the equipment has
been stored, installed, operated, inspected, and maintained in accordance with
recommendations of the seller and standard industry practice, to correct the non-
conformity either by repairing any damaged or defective parts of the equipment
or (at the seller’s option) by shipment of necessary replacement parts. The seller’s
warranty does not apply to any equipment that has been disassembled, repaired, or
altered by anyone other than the seller. This limited warranty is granted only to the
immediate purchaser or, if the equipment is purchased by a third party for instal-
lation in third-party equipment, the end user of the equipment. The seller’s duty to
perform under any warranty may be delayed, at the seller’s sole option, until the
seller has been paid in full for all goods purchased by the immediate purchaser.
No such delay shall extend the warranty period. Replacement parts provided by
the seller or repairs performed by the seller under the warranty for the original
equipment will be covered by the above special warranty provision for its duration.
Replacement parts purchased separately will be covered by the above special war-
ranty provision.
Warranty
Qualifications
Warranty of GridMaster Microgrid Control System is contingent upon the installation,
configuration, and use of the control and software in accordance with S&C’s applicable
instruction sheets. This warranty does not apply to major components not of S&C
manufacture, such as batteries, communication devices, and the IED associated with
the controller. However, S&C will assign to the immediate purchaser or end user all
manufacturers’ warranties that apply to such major components.
