Inserting the Communication Module Into the Base
Figure 22. Inserting the communication module into the base.
The communication module can be installed from a bucket
truck with the module handling fitting, catalog number
4450, attached to a suitable hookstick.
CAUTION
The communication module is heavy, weighing
more than 26 pounds (12 kg).
S&C does not
recommend removal and replacement from the
ground using an extendostick . This may cause minor
injury or equipment damage .
Remove and replace the communication module
from a bucket truck using the module handling fitting
attached to a suitable hookstick .
Follow these steps to install the communication
module:
STEP 1.
Inspect the wiring connectors and insertion
guides of the communication module and
communication module bay for damage. See
Figure 21.
STEP 2.
Push the handling fitting into the module latch
and simultaneously turn the fitting 90 degrees
counterclockwise.
STEP 3.
Position the communication module so the
alignment arrows line up, and insert the module
into the left bay of the base as shown in
Figure 22. Push very hard to engage the
connectors.
STEP 4.
While pushing up on the hookstick, rotate the
handling tool 90 degrees clockwise (as viewed
from the underside of the base) to close the
latch. Then, remove the fitting.
Figure 21. A communication module removed from the
IntelliRupter fault interrupter base.
S&C Instruction Sheet 766-526 15
