S&C Instruction Sheet 766-510
13
Installation
Figure 15. Battery inside the communication module.
Figure 14. Inserting a battery into the communication module.
Figure 13. Communication module battery door.
Battery
NOTICE
The lower terminal-pad cover is shipped installed on
the disconnect side of disconnect-style IntelliRupter
fault interrupters. Attach the compression lug or
the terminal-pad connector using the hardware
provided. Install the upper terminal-pad cover and
tap cover as described on page 12.
Installing Communication Module Battery
STEP 9.
The 12-Vdc, 8-ampere-hour battery pack for the
communication module, if supplied, is shipped
separately in the carton containing the
communication module (SDA-4554). If the
IntelliRupter fault interrupter has been in storage
for more than six months, the battery should be
charged. Do not install the battery if the module
will not be energized for more than three days.
To install the battery:
(a) Loosen battery compartment cover locking
screw. See Figure 13.
(b) Insert the battery assembly; push it most of the
way in. To connect the battery leads, push the
connector halves together until the tab on the
lower-connector half engages the fi
xed-
connector half. Push battery assembly all the
way in. See Figure 14.
(c) Inspect the battery compartment gasket. Close
the battery compartment cover and secure the
locking screw. See Figure 15.
Installing a Radio
STEP 10.
A radio providing wide-area network capability
for SCADA applications, if specifi ed, is furnished
factory-installed in the communication module.
Alternatively, a user-furnished radio can be
installed in the fi eld. Some radios must be
programmed using a cable connected to a
computer. In such instances, you must remove
the radio tray assembly to connect the radio, and
power the radio with the battery or a separate
power supply. Refer to S&C Instruction Sheet
766-520, “S&C IntelliRupter® PulseCloser®
Fault Interrupter:
Wi-Fi, SCADA, and GPS
Communication Setup Instructions
.”
Lower connector half
Fixed connector half
Locking screw
