S&C Instruction Sheet 1072-530
53
SpeedNet Client Tool
Admin Window,
System Tab
Figure 80. The System Admin configuration window.
The
Admin
window has tabs that can be used to perform administrative tasks for the
SpeedNet Radio that include upgrading fi rmware and determining system information.
Selecting a tab will
provide a list of confi gurable options.
The
System
tab, shown in Figure 80, is used to view system information, such as the
current firmware version. System information, including radio ID and location, can be
entered by the administrator. The following parameters can be configured:
• MIB_Version
—This read-only field provides information regarding the current
management information base (MIB) that is being used by the SNMP protocol
• Firmware_Version
—This read-only fi eld displays the current fi rmware version
installed on the SpeedNet Radio
• Running Time
—
This read-only fi eld displays the elapsed time since the last time the
SpeedNet Radio was rebooted.
• SpeedNet Radio ID
—Administrators can use this fi eld to assign a descriptive name
to the SpeedNet Radio. The SpeedNet Radio ID must consist of ASCII values but cannot
contain spaces or the following characters: $, ^, &, (, or )
• System Name
— Administrators can use this fi eld to assign a descriptive name to the
entire network. The System ID must consist of ASCII values
• System Location
— Administrators can use this fi eld to note the location of the net-
work. The System ID location must consist of ASCII values. The convention for location
is for the system location to be in the form <signed decimal latitude>:<signed decimal
longitude>. For example, a System Location of
33.578014746144: -101.865234375
is in Lubbock, Texas USA
• System Contact
—Administrators can use this fi eld to list the point of contact for the
SpeedNet Radio network. The System ID must consist of ASCII values.
• Apply
—
Saves changes made to the confi guration of the
System
tab. Changes will
not be saved if you change to a different confi guration tab without fi rst clicking the
Apply
button
• Reboot
—Clicking the
Reboot
button will cause the SpeedNet Radio to reboot