S&C Instruction Sheet 461-500
13
45°
20°
Installation
STEP 5.
Insert the straight prong of an S&C Talon Handling
Tool or a distribution prong into the pull-ring.
Swing TripSaver Dropout Recloser to within
approximately 45° of the fully closed position as
shown in Figure 9. Then drive TripSaver Dropout
Recloser to the closed position using a vigorous
thrust while firmly gripping the hookstick.
Carefully disengage the prong from the pull-ring,
taking care to avoid pulling open TripSaver Dropout
Recloser.
WARNING
DO NOT
use the curled prong on an S&C Talon tool to
close TripSaver Dropout Recloser .
Using the curled
prong of a Talon tool to close TripSaver Dropout
Recloser can prevent full closure, resulting in arcing,
equipment damage, serious injury, or death.
With the mode selector handle in the AUTO posi-
tion, TripSaver Dropout Recloser will operate nor-
mally according to its operating sequence: Open-5
seconds-Close-Open-Dropout-5 seconds- Close.
Figure 9. Swinging TripSaver Dropout Recloser to within 45° of
the fully closed position before final closing.
Summary of Contents for TripSaver
Page 24: ......
