13
SLAVE PRICE SETTING ROUTINE
(PROTECTED MENU SHOWN ONLY IF SLAVE IS ENABLED)
The function is the same as the previous menu, only the set prices are for the Slave
machine, and the menu is called “PRIC S”
MASTER SPACE TO SALES SETTING ROUTINE (PROTECTED MENU)
This function is used to recognise the number and the position of the motors installed in
the machine. This configuration must be used every time one or more motors are added or
taken off.
If the ENTER button is activated at the "STOS” prompt the VMC will show “AUTO”.
Pressing again selection 4 on “AUTO” menu, the machine starts from column 11 to column
88 and TESTs all the motors installed (near the number of the motor TESTed OK will
appear if the motor works correctly, if not NO will appear if the motor is not installed or if
defective.
The auto-configuration takes 4 minutes to be completed.
Special functions:
- This configuration is stored in a non volatile memory you can stop this
auto- configuration keeping pressed selection 1.
- Pressing selection 5 on “AUTO” menu, the machine will enable all the motors
without TESTing them (this is useful to TEST defective motors).
- Pressing selection 0 on “AUTO” menu, the machine will TEST only the motors
that haven’t already been found by the VMC.
SLAVE SPACE TO SALES SETTING ROUTINE (PROTECTED MENU SHOWN ONLY IF
SLAVE IS ENABLED)
The function is the same as the previous menu, only the set prices are for the Slave
machine and the menu is called “STOS S”.
MACHINE CONFIGURATION SETTING ROUTINE (PROTECTED MENU)
If the ENTER button is activated at the "CON" prompt the VMC will enter the machine
configuration setting routine. The display will show a "C01" message where the "01"
indicates configuration setting number 1. Using UP and DOWN button will cycle through
the available configuration setting numbers. Activation of the ENTER button while a
configuration setting number is displayed will allow access to the current setting number of
the displayed configuration setting.
Activation of the ENTER button will save the displayed configuration.
Activation of the HOME button while configuration is displayed, without doing an ENTER
before, will return the VMC to the "CON" display without saving the displayed
configuration. Push button # 2 to advance to the next menu. Activation of the HOME
button returns to unprotected area.
Summary of Contents for Vendo G-SNACK
Page 1: ...G SNACK G SNACK PLUS MASTER SLAVE PROGRAMMING MANUAL...
Page 3: ...2...