④
Move the prism according
to the graphic. When
bothlongitude and latitue
arrowhead display zero, it
means the stake-out point has
been found; H means the
filling. Method to stake our is
the same to “5.6 Stake Out”.
※
2)
【
Stake Out
】
PtID
:
3
m
Of
:
0.058 m
0.000m
R.HT
:
1.500 m
Ln
:
1.971
H
:
2.128
m
All DIST CHECK
↓
0.000 m
0.369 m
※
1) To shift the line horizontally, press [F3] ([ShiftL]).
※
2) Longitude offset direction is positive (Arrowhead upwards)
:
Target point is further away
from measurement point.
Latitude offset is positive (Arrowhead rightwards): Target point is on the right of measrement
point
H is positive (Arrowhead upwards)
:
Target point is higher than measurement point.
The height of the line start point is always used as the refernce height.
The graphics are scaled to give a better overview. Therefore it’s possible that the station point
in
Be aware that the line start point and the line end point are measured in the previous
coor
staking our this points they appear in the old system and appear as
shifted.
During the operation the the application, the previou Orientation and Station parameters will
be the new calculated ones.
moves the graphic.
dinate system. When
161
Summary of Contents for STS-750
Page 6: ...6...