Chapter 6. Sound Settings
51
certain frequency limit, much as the “bass” control found on ordinary stereo sys-
tems does. Adjust the “cutoff” frequency parameter to decide where the shelving
starts to take effect. For example, a cutoff frequency of 50 Hz will adjust only very
low frequencies. A cutoff frequency of 200 Hz, on the other hand, will adjust a
much wider range of bass frequencies. The “gain” parameter controls how much
the loudness of the band is adjusted. Positive numbers make the EQ band louder,
while negative numbers make that EQ band quieter. The “Q” parameter should
always be set to 0.7 for the shelving filters. Higher values will add a small boost
around the cutoff frequency that is almost always undesirable.
Bands 1-8: Peaking filters.
Peaking EQ filters boost or lower a frequency range cen-
tered at the centre frequency chosen. Graphic equalizers in home stereos are usually
peaking filters. The peaking filters in Rockbox’s EQ lets you adjust three different
parameters for EQ bands 1 through 8. The “centre” parameter controls the centre
frequency of the frequency range that is affected as described above. The “gain”
parameter controls how much each band is adjusted, and works as for the low shelf
filter. Finally, the “Q” parameter controls how wide or narrow the affected fre-
quency range is. Higher Q values will affect a narrower band of frequencies, while
lower Q values will affect a wider band of frequencies.
Band 9: High shelf filter.
A high shelf filter boosts or lowers all frequencies above a
certain frequency limit, much as the “treble” control found on ordinary stereo
systems does. The high shelf filter is adjusted the same way as the low shelf filter,
except that it works on the high end of the frequency spectrum rather than the
low end.
As a general guide, EQ band 0 should be used for low frequencies, EQ bands 1 through
8 should be used for mids, and EQ band 9 should be used for highs.
Enable EQ.
This option controls whether the EQ is on or off.
Graphical EQ.
This option brings up a graphic EQ screen, which allows adjustment of
each of the three parameters described above (gain, centre frequency, and Q) for
each of the five EQ bands.
Key
Action
Right
Raises the highlighted parameter.
Left
Lowers the highlighted parameter.
Play
Moves to the previous EQ band.
Submenu
Moves to the next EQ band.
Select
Toggles the cursor among the three pa-
rameters (gain, centre frequency, Q) for
the selected EQ band
Power
Exits the graphic EQ screen.
The Rockbox manual
(version 3.14)
Sansa Clip v2
