Know your Styler
How to use your Styler
Heat up
- Swing the heat stand forward and place the styler on a flat, level, heat
resistant surface, close to a power outlet.
- Plug the styler into the power outlet and switch on.
- Slide the power switch to ON.
- The power on light will illuminate.
- Allow 5 minutes for the styler to reach optimum temperature.
Using the Styling Tong
- Your hair should be dry and brushed / combed to remove any tangles.
- Take a section of hair no wider than 25mm. For longer / thicker hair
use smaller sections.
- Start at the nape of the neck and work upwards and outwards, finishing
up at the top of the head.
- Press the tong lift button to raise the tong.
- Put the ends of the hair section between the tong and the barrel.
- Release the tong lift button, to secure the ends of the hair.
- Rotate the handle to wind the hair round the outside of the tong. You
may find this easier if you hold the cool touch tip loosely with the other
hand.
- Keep the hot metal of the barrel and tong away from your scalp.
- Leave the tong in place for 10-15 seconds. The time may vary
depending on the length and thickness of the hair. Longer / thicker hair
will need a longer styling time, while shorter / finer hair will need a
shorter styling time.
- Unwind carefully, raise the tong to release the end of the hair, then
leave the curl in position until it cools.
- For a spiral effect, use small, square sections of hair and wind them up
the barrel.
HEAT STAND
STYLER
BODY
STYLING
TONG
STYLING
BRUSH
ON / OFF
SWITCH
INDICATOR
LIGHT
TONG LIFT
BUTTON
COL TOUCH
TIP
Summary of Contents for CARMEN PARIS 2-IN-1 STYLER
Page 1: ......