3
1. INTRODUCTION
Thank you for purchasing this appliance. It has been manufactured in full compliance with applicable safety regulations
and EU standards.
Please read this instruction book carefully, as it contains important information for your safety during the installation,
use and maintenance of this product.
Keep it at hand for future reference.
Please check that the appliance is in perfect condition when you unpack it, as all factory defects are covered by the S&P
guarantee.
2. SAFETY REGULATIONS AND “CE” MARKING
S&P technicians are firmly committed to research and development of ever more efficient products and in compliance
with current safety regulations.
The instructions and recommendations given below reflect current regulations, principally regarding safety, and the-
refore are based on compliance with general regulations. Therefore, we recommend all people exposed to hazards to
strictly follow the safety regulations in force in your country. S&P will not be held liable for any possible harm or damage
caused by non-compliance with the safety regulations, as well as caused by modifying the product.
The CE mark and the corresponding declaration of conformity are proof of the product’s conformity with current EU
regulations.
3. GENERAL INSTRUCTIONS
A hazard analysis of the product has been carried out as provided in the Machine Directive. This manual contains infor-
mation for all personnel exposed to these hazards, with the aim of preventing possible harm or damage due to faulty
handling or maintenance.
All maintenance operations (ordinary and extraordinary) must be carried out with the machine switched off and the
electrical power supply disconnected.
To avoid a possible accidental start up, place a warning notice on the electrical control panel with the following text:
“Attention: control disconnected for maintenance operations”
Before connecting the power supply cable to the terminal strip, make sure the mains voltage corresponds to the voltage
indicated on the specifications plate of the unit.
Regularly check the product labels. If, due to the passing of time, they are no longer legible, they must be replaced.
4. UNIT LABELLING
The machine may come with several pictograms that must not be removed. These signs are divided into:
• Prohibition signs: Do not repair or adjust when in operation.
• Danger signs: Warning of the presence of live elements inside the container bearing the sign.
• Identification signs: CE card, indicating product information and manufacturer’s address. The CE mark indicates the
product’s conformity with EEC standards.
Danger signs
Prohibition signs
Summary of Contents for CAD-COMPACT 500
Page 1: ...EN CAD COMPACT ECOWATT...
