6
7
ENGLISH
DESCRIPTION OF THE APPLIANCE (FIGURE 1)
1. Hair dryer.
2. Wall-mounted support.
3. Transparent cover.
4. Indicator light.
5. Main ON / OFF switch.
6. Shaver socket.
7. Operation switch.
8. Drying speed / temperature selector (MIN / MAX).
INSTALLATION (FIGURE 2)
• Carefully read the safety warnings listed above before installing the appliance.
• Drill two vertically aligned holes separated by a distance of 140 mm.
• Insert the wall plugs provided. The bag of accessories also contains a small plastic support (A).
Use the shortest screw provided to secure the support to the wall, using the bottom hole.
• Slot the rear ridge of the appliance on to the plastic support (A) and secure the entire unit to the
wall using the longest screw. Use the plastic cap provided (B) to cover the head of the screw.
CONNECTION TO THE MAINS
• Carefully read the safety warnings listed above before installing the appliance. Ensure that the
power is completely disconnected.
• Ensure that the mains cables have the required gauge for the power of the appliance
(1,200W / 5.5 A). Class II appliances do not require an earth connection.
• The appliance is supplied equipped with a power cable for direct connection to a power point.
If you wish to connect the appliance directly to the mains, follow the steps
described below (Figure 3).
• Locate the two screws underneath the transparent cover and remove them. Then remove
the four screws located on the back of the support.
• Disconnect the cables connected to the terminal block (L-N terminals). Then remove the
fixing flange (C) and the power cable with the plug.
• Drill a hole in the bottom plastic cover in the area designed for cable entry (D).
• Connect the mains cables as per the connection data sheet:
L
(brown) //
N
(blue).
• Re-mount the appliance, replacing the 6 screws you removed earlier. The bag of accessories
contains a plastic cover (E) that can be used to cover the cable entry hole.
Summary of Contents for COMET-P
Page 2: ...Fig 1 Fig 3 Fig 2 ...
Page 39: ...39 ...
