ERV
TRC1600
9
WWW.SOLERPALAU-USA.COM
INSTALLATION, OPERATION AND MAINTENANCE MANUAL
1.800.961.7370
ELECTRICAL SPECIFICATIONS
NOTE:
Proper Wiring Size Selection and Wiring
Installation are the Responsibility of the Electrical
Contractor.
Blower & contactor voltages are specified with
order and set at factory.
Brake Horsepower at various Blower RPM, Motor
Rating, and ESP combinations are available on
Spec Sheet or from factory.
Electrical Options and Ratings are on the Unit Label
(located near electrical box). Find the complete
Unit Model Number in the lower left corner of the
Unit Label.
MOUNTING THE UNIT
The TRC1600 is manufactured with four screw-
adjustable legs for installation at floor level in an
upright position.
The TRC1600 may also be hung on the wall or
suspended from a ceiling. Screw or bolt mounting
straps or brackets directly to the sheet metal case
as necessary. Sheet metal screws should not
penetrate further than ½" into case. Make sure
your fasteners don’t damage internal parts. Do not
screw into the door.
Note that leveling legs supplied with TRC1600 can
be removed and replaced with 3/8" bolts to secure
unit to mounting brackets, located under the unit.
Do not hang the unit from these threaded inserts.
The TRC1600 weighs approximately 414 lbs. It is
the installer’s responsibility to make sure that the
screws or bolts used for securing the units are
properly selected for the loads and substrates
involved. Secure the TRC1600 so that it cannot fall
or tip in the event of accident, structural failure or
earthquake.
CAUTION
Secure the TRC1600 with straps or clamps so that it
cannot fall or tip in the event of accident, structural
failure or earthquake.
WARNING
Danger of Electrical Shock when servicing an
installed unit.
ALWAYS DISCONNECT POWER SOURCE BEFORE
SERVICING!
More than one disconnect switch may
be required.
Proper Wiring Size Selection and Wiring Installation
are the Responsibility of the Electrical Contractor.
WARNING
INSTALLATION INSTRUCTION
INSTALLATION
