S&P JENcoFAN EO, Installation, Operation And Maintenance Manual

2

INTRODUCTION:

DO NOT INSTALL, USE OR OPERATE THIS EQUIPMENT UNTIL THIS MANUAL 

HAS BEEN READ AND UNDERSTOOD. READ AND SAVE THESE INSTRUCTIONS 

FOR FUTURE USE. 

This document is the property of the owner of this equipment and is required for future 

maintenance. Leave this document with owner after installation or service has been 

completed.

It is the responsibility of the purchaser to assure that the installation and maintenance of this 

equipment is handled by qualified personnel experienced in such work and equipment.

We strongly suggest hood Installation should only be performed by a qualified and 

licensed mechanical contractor who is familiar with the level of involvement for proper 

installation. Ensure proper safety precautions are taken, permits are obtained, and code 

requirements are met.  

Contact your local representative should you need further information.

SHIPMENT AND RECEIVING:

Prior to shipment, all fans have been thoroughly inspected and tested.

All equipment shipped from S&P is skidded or crated to fully comply with trucking 

requirements. Inspect all shipments carefully for damage. 

THE RECEIVER MUST 

NOTE ANY DAMAGE ON THE CARRIER’S BILL OF LADING AND FILE A CLAIM 

IMMEDIATELY WITH THE FREIGHT COMPANY, IN THE CASE OF ANY DAMAGE.

Keep a record of all equipment received, including inspection details and date of receipt, 

because of the possibility of partial shipments.

If you receive damaged goods, contact your manufacturer’s representative for repair or 

replacement service.

HANDLING:

Handle your equipment with caution

STORAGE:

If hoods are stored for any length of time, they should be stored in a clean, dry location to 

prevent rust and corrosion. Outdoor storage is not recommended. When outdoor storage is 

necessary, they should be protected from the elements.