SandPro 4517, Owner'S Manual

SAVE THESE INSTRUCTIONS

9

5 .  Securing the filter assembly .

a .  Install the main tank seal around the bottom of the 7 position multi-port valve .  

See Figure 6 . 

NOTE:

 Apply a good amount of silicone grease or pool lube around the seal 

before installing it onto the valve . This will allow for an easier installation and 

provide a better seal .

b .  Install the valve onto the filter tank using the clamp ring and securing it with the included 

5mm hex key . Make sure that the top of the manifold assembly fits into the bottom of the 

valve . Tighten clamp until there is less than a 

1

⁄

8

” gap between the 2 halves of the clamp . 

c .  Install all 3 threaded connectors (with o-rings) onto the valve . See Figure 6 . 
d .  Install the pressure gauge . Do not to over tighten .  

See Figure 6 . 

e .  Install the included hose from the pump outlet port to the  

filter intake port . Secure with the provided hose clamps . 

NOTE: For smaller hoses a rubber reducer may be used .  

See Figure 7 .  

6 .  Completed Assembly
   The basic Filter-to-Pump Assembly should resemble Figure 7 .

cautiOn

Ensure ALL hose connections are tight and the hoses 

are NOT kinked or bent at severe angles. If the hoses are 

leaking, check to make sure ALL of the parts with o-rings 

have them attached and are screwed on tightly.  

DO NOT over tighten hose clamps (35 in/lb max torque).

Figure 6

Figure 7

Hose  

Connectors

Hose  

Connector

Pressure 

Gauge

Main Tank Seal

Clamp Ring 

Assembly

Completed 

Assembly

Filter 

Intake Port

Pump 

Outlet Port

Hose  

Clamp

Hose  

Clamp