S&S Northern Ltd. Wallace Francis House, Barnes Wallis Way, Buckshaw Village, Lancashire, PR7 7JN T. 01257 470983 www.snsnorthern.com
Page left and right to access other operating pages
Override will show either Start Manual Override or Cancel Manual Override.
Home This is the default screen, this screen displays date, time and system status.
Modes Use OK to switch between Normal 2 guard and single Permanent High Mode. Also displays power source and me-
ter readings.
Audit The audit page records the maximum and minimum litres of water used in a period. The period can be half hour,
one hour, guard period or 24 hours depending on system settings.
Data will display the history of Minimum and Maximum Litres used in any 60 seconds.
Events Log displays a record of events with times and dates.
TO TEMPORARILY OVERRIDE THE GUARD LIMITS –
From Home go left to Override. Press OK to Start Manual Override Countdown. To Cancel Override, go left again from
Home page and press OK.
The default override time is 30 minutes. This can be changed between 10 and 45 minutes. The override allows unlimited
water to flow during this period.
THE GUARD MENU
To access the guard menu push both the Up and Down keys together for 2 seconds.
HI GUARD VAL: Push OK to change and confirm the maximum value in litres/hour (default: 2)
LO GUARD VAL: As above, but for when the property is occupied (default: 50)
OVERRIDE TIME: Push OK to increase from 10 minutes to 45 minutes maximum (default: 30)
METER READINGS: Push OK, navigate to match the actual water meter reading.
DATE: Push OK to select and confirm the date. Use the Up and Down keys to adjust the date.
TIME: Push OK to select and confirm the time. Use the Up and Down keys to adjust the time.
MODE: Select mode: • DAILY - every day is the same • SEVEN DAY - day by day • WEEKEND/WEEKDAY - two settings for
the whole week • ALARM – Automatic (for systems connected to an intruder alarm)
SET HI/LO Times: Push OK to access the 7 day timer. To set the LOW GUARD start to finish periods use the navigation
keys. If only one period is required set both 1 and 2 the same
To Excit Guard Menu, push (left) at any time
THE ENGINEERING MENU
To access the engineering menu push the left, right and down keys together for 3 seconds.
FLOW PER: Push OK to select between hourly , half hourly, guard and day metering (default: hour)
PULSE: Push OK to select between one pulse per 1 litre, or one pulse per 10 Litres and one pulse per 100 Litres (default: 1
litre)
VALVES: Push OK to select valves, None; Both; Valve 1 only; or Valve 2 only (default: Both)
METERS: Push OK to select meters, None; Both; Meter 1 only; or Meter 2 only (default: Both)
LEAK: Push OK to select
LEAK Settings. Close all; Close Single.
CLOSE VALVE: Push OK to close the valve when a High Guard period is selected (default: No)
