9
Display Backlight
There are four backlight levels for you to select from when in the Standby and On modes.
To set the backlight, press the BACKLIGHT button repeatedly and the brightness of the
display will change in the below sequence on every press:
Backlight off > Backlight 01 > Backlight 02 > Backlight 03 > Backlight off >……
During standby mode, the backlight will be set to full brightness for 5 seconds on every key
press.
The display backlight level default is “Backlight 01” in AC standby and
“Backlight 03” during operation.
System Reset
There may be times when you need to reset your unit back to the factory settings especially
when you have moved house. If you experience reception problems you may want to reset
and try again. If you move to another part of the country and pick up the local and national
DAB stations in that area, your previously tuned channels may no longer be available.
1. Press and hold the MENU button until the “Press SELECT to confi rm reset” shows on
the display.
2. Press the OK dial to start the system reset, “Restarting…” will show on the display.
After the reset is complete, the unit will go to standby mode.
3. Press the button again to turn the unit on, the unit will then start scanning for DAB
channels immediately.
After the system reset, all the tuned stations, DAB & FM preset stations and
alarm settings will be erased.
Software Version
1. Press and hold the INFO button for 2 seconds and then release it to view the software
version of this unit.
2. The software version will automatically disappear after 5 seconds.
