FLATMAN ECO / PRO – User Manual
s&t embedded GmbH
– Gutenbergstr. 2 – 85737 Ismaning - Germany
Phone: +49 89 370058 – 0 Fax: +49 89 37000 689
Mail to: info@snt-embedded.de
www.snt-embedded.de V1.7
6
3 General Safety Instructions
The ext. supply shall meet the criteria for SELV (Safety Extra-low Voltage) and <240VA acc. UL 60950-1.
It must be assumed that safe operation is no longer possible, if the device has visible damage or if the device
no longer functions. In these cases the device must be shut down and secured against unintentional
operation.
Please read this section carefully and observe the instructions for your own safety and correct use of the
device. The chapter also contains information on approval and interference suppression of your device.
Observe the warnings and instructions on the device and in the manual.
In order to maintain this condition and ensure safe operation, the user must observe the instructions and
warnings contained in this manual.
•
The device must be used in accordance with the instructions for use.
•
The electrical installations in the room must correspond to the requirements of the local (country-
specific) regulations.
•
Take care that there are no cables, particularly power cables, in areas where persons can trip over
them.
•
Only use the power cord supplied. Don’t use injured or damaged power cords.
•
For DC power connection:
The DC power source should be able to be switched off and on via an isolating switch.
The unit is only completely disconnected from the DC main power source, when the DC power cord is
disconnected either from the power source or the unit. Therefore, the DC power cord and its
connectors must always remain easily accessible.
•
For AC power connection via external AC/DC adapter:
The main power cable of the external AC/DC adapter serves as disconnecting device. For this reason
the outlet of the AC power source must be located near to the device and be easily accessible.
•
Do not place the device in direct sunlight, near heat sources or in a damp place. Make sure the device
has adequate ventilation.
•
Only devices and components which fulfill the requirements of an SELV circuit (safety extra low
voltage) in accordance with EN60950 may be connected to the interfaces of the system.
•
All plugs on the connection cables must be screwed or locked to the housing.
•
The device generates heat during operation. Make sure it is adequately ventilated. Do not cover the
air intake and exhaust openings of the device.
•
Repairs may only be carried out by qualified specialist personnel authorized by S&T.
•
Maintenance or repair on the open device may only be carried out by qualified personnel authorized
by SNT which is aware of with the associated dangers.
•
When accessing internal components the device must be switched off and disconnected from the
power source.
