KBox C-103-NGSF - User Guide, Rev. Proof of Concept
www.kontron.com
// 41
5.1.
Top Cover
The pictures in this section correspond to a KBox C-103-NGSF system.
The cover description can be applied to all system variants, under
consideration of the different mechanical specifications of the KBox
C-103-NGSF
When used as intended the KBox C-103-NGSF is to be operated only in
closed condition.
Only when the right side cover is fixed with the screws (Figure 17,
pos. 2) and top cover is properly installed and secured with the
knurled screws (Figure 9, pos. 2) on the front side, it is ensured
that the user doesn’t have access to the internal components of the
KBox C-103-NGSF during operation.
The cover will be fixed to the chassis using the centring bracket at the rear side of
the cover (Figure 23, pos. 3) and the fixing bracket with captive knurled screws at the
front side of the cover (Figure 23, pos. 5).
When inserting the cover, make sure that:
At the rear: the centring bracket (Figure 23, pos. 3) is inserted properly into the
corresponding cover retaining bracket of the chassis
At the front side: the fixing bracket with captive knurled screws of the cover
(Figure 23, pos. 5), is matching properly over the cover retaining bracket on the
front side
The fixing bracket with captive knurled screws (Figure 23, pos. 5) secures the top
cover on the front side (Figure 9, pos. 2).
Figure 23: Inside of the top cover with centering and fixing brackets
2
3
1
4
5
