KSwitch D1 UGPD Unmanaged Gigabit PoE Ethernet Switch - Preliminary User Guide, Rev. 0.9
// 20
Table 4:PoE Ports (PSB, PSE and PD)
PoE
Condition
PSB Output (PoE++)
60 W, 1.2 A
V1+ pins 1, 2, V1- pins 3, 6
V2+ pins 4, 5, V2- pins 7, 8
PSE Output (PoE++)
30 W, 600 mA
V1+ pins 1, 2, V1- pins 3, 6
PD Input (PoE++)
56 VDC and 60 W
4.1.2.
Indicator LEDs (B, E, PWR, Ethernet)
The LEDs indicate the normal operation of the switch and in the case of failure may be used for faultfinding.
Figure 4: Indicator LEDs
1
PSB and PSE Link/Act LEDs
2
Power fault indicator LED
3
RJ45 Copper Link/Act & Speed LEDs
Table 5: Indicator LEDs
LED Name
Indicator /Color Condition
B (Link/Act)
On Blue
PoE on PSB port is working
Off
PoE on PSB port is not working
Off
PoE on PSE port is not working
[1]
E (Link/A)
On Blue
PoE on PSE port is working
Off
PoE on PSE port is not working
PWR
On Green
Power line has power
Off
Power line disconnect or does not have supply power
RJ45 Copper Port
(Link/Act)
On Green
Ethernet link up but no traffic is detected
Flashing Green
Ethernet link up and there is traffic detected
Off
Ethernet link down
RJ45 Copper Port
(Speed)
On Yellow
1000Mbps connection detected
Off
No link, a 10Mbps or 100 Mbps connection is detected
[1]
PSB port is used for data transmission and PSE function
1
3
2
