KSwitch D1 UGPD Unmanaged Gigabit PoE Ethernet Switch - Preliminary User Guide, Rev. 0.9
// 28
5.2.
DIN-Rail Removal
To remove the switch on a DIN-Rail, perform the following:
1.
Push the switch down to free the bottom of the DIN-Rail clip from the DIN-Rail.
2.
Rotate the bottom of the switch away from the DIN-Rail
3.
Unhook the top of the DIN-Rail clip from the DIN-RaIl by lifting upwards.
5.3.
Wall Mount Bracket
To mount on a flat surface or wall use the Wall Mount Kit with wall mount L brackets. The wall mount L brackets
fasten to the mounting holes on the left and right sides of the switch.
Figure 14: Wall Mount L Bracket
1
2x mounting holes to fasten to
switch
2
2x key holes for surface mounting
3
2x mounting holes for surface mounting
Figure 15: Wall Mount L Bracket Mounting Holes Location
If a DIN-Rail clip is installed, remove the DIN-Rail clip before installed the wall mount L
brackets.
If the bottom side heatsink is installed, users may be required to remove the bottom side
heatsink before installing the two wall mount L brackets.
2
1
3