KSwitch D3 UM Unmanaged Fast Ethernet Switch - Preliminary User Guide, Rev. 0.9
// 28
5.3.
Wall Mounting
To mount on a flat surface or wall use the Wall Mount Kit, see Table 2: List of Accessories. The number of wall mount
plates required to mount the switch and the position of the wall mount plates on the rear side of the switch, depends
on the switch’s port variant.
Figure 14: Wall Mount Plate
1
2 screws hole to mount on the
switch
2
Grove to mount with screw on a wall or
flat surface
Table 5: Wall Mount Plates
Wall Mount Plate Position
10-port
18-port
50-port
To install the wall mount plates supplied in the Wall Mount Kits, perform the following:
1.
Make sure the mounting surface is clean and smooth and meets the thickness requirement of the screw.
2.
Aline the wall mount plates to the correct threaded holes (top and bottom/left and right) on the rear side of the
switch.
Mount on a wall or flat surface using the correct number of wall mount plates and screws to
ensure the switch is secure.
3.
Fasten the wall mount plates to the switch (top and bottom/ left and right) using the M3, 5 mm screws provided.
4.
Mount the switch to a wall or flat smooth surface by inserting screws into each wall mount plate’s grove and
fastening firmly.
1
2
