KSwitch D3 UMP Unmanaged PoE Ethernet Switch - User Guide, Rev. 1.0
// 27
Figure 13: Wall Mount Plate Location
The distance from the wall mount plate’s mounting holes to the top of the wall mount plate
is 27 mm.
To install the wall mount plates supplied in the Wall Mount Kits, perform the following:
1.
Make sure the mounting surface is clean and smooth and meets the thickness requirement of the screw.
2.
Aline each wall mount plate to the correct threaded holes (top and bottom) on the rear side of the switch.
Mount on a wall or flat surface using the correct number of wall mount plates and screws to
ensure the switch is secured properly.
3.
Fasten the wall mount plates to the switch (top and bottom) using the screws (length 5 mm & size M3) provided.
4.
Mount the switch to a wall or flat smooth surface by inserting screws into each wall mount plate’s grove and
fastening firmly.
143.2 mm
131.3 mm
27 mm
27 mm
