KSwitch D4 MF Managed Fast Ethernet Switch - User Guide, Rev. 1.0
// 29
5.3.
Wall Mounting
To mount on a flat surface or wall use the Wall Mount Kit, see Table 2: List of Accessories. Two wall mount plates are
required to mount the switch.
Figure 12: Wall Mount Plate
1
2 screws hole to mount on the
switch
2
Grove to mount with screw on a wall or
flat surface
Table 5: Wall Mount Plates
The distance from the wall mount plate’s mounting holes to the top of the wall mount plate
is 27 mm.
To install the wall mount plate supplied in the Wall Mount Kit, perform the following:
1.
Make sure the mounting surface is clean and smooth and meets the thickness requirement of the screw.
2.
Aline the wall mount plate to the correct threaded holes (top and bottom) of the rear side of the switch.
Mount on a wall or flat surface using the correct number of wall mount plates and screws to
ensure the switch is secured properly.
3.
Fasten the wall mount plates to the switch (top and bottom) using the screws (length 5 mm & size M3) provided.
4.
Mount the switch to a wall or flat smooth surface by inserting screws into each wall mount plate’s grove and
fastening firmly.
1
2
27 mm
27 mm
