SBOX-5210 - User Guide, Rev. 1.0
// 36
7.1.
System Mounting
In order to adapt the SBOX-5210 for mounting Kontron offers different mounting solutions such as:
SBOX-5210 configuration with rubber feet for horizontal installation on the desktop as desktop unit
SBOX-5210 configuration with a desk stand kit for vertical installation on the desktop as desktop unit
SBOX-5210 configuration with a wall mount kit for vertical installation on a wall / other support surface or
inside a custom enclosure / machine
SBOX-5210 configuration with a VESA mounting kit for vertical installation on the back of a monitor, on a wall /
other support surface or inside a custom enclosure / machine
7.1.1.
Desktop Installation --- Horizontal
SBOX-5210 is supplied with four rubber feet (Figure 9, pos. 1) as well as four screws (Figure 9, pos. 4).
Figure 9: Rubber feet
1 Rubber Foot
2 Screw
To install the SBOX-5210 please proceed according to the steps described:
1.
Place the rubber feet (Figure 9, pos. 1) onto the bottom side of the chassis by aligning their holes with the
corresponding screw holes on the chassis.
2.
Secure the rubber feet to the chassis by the supplied screws (Figure 9, pos. 2).
Figure 10: Securing the rubber feet to the chassis
1
1
1
1
2 2 2
2
