Operation
12
Always select the direction of rotation for treatment the nails in
their direction of growth. If possible, treat the nails from the
outside towards the inside (to the nail tip). Otherwise, the nails
will split more easily.
If you feel that the nails could crack during treatment, select the
other direction of rotation.
While you are working, never let the attachments remain on one
location. Friction leads to increased heat generation and may
case injuries.
Excessive speeds and applying too much pressure can cause
the sapphire disc to rapidly penetrate into deeper, healthy skin
layers. This can cause injuries and damage to the periosteum!
When using the sapphire cone (a), the felt cone (b) and the
flame miller (g), always work with a circular motion.
The attachments do not have as much effect on softened skin.
Therefore, do not carry out any pre-treatment in a water bath
before using the unit.
If you are treated hardened skin, apply a moisturising cream to
the treated areas after completing the procedure.
Operation
Find a well-lit place to work.
1. Insert the desired attachment for your purpose in the drive collet.
(1). The attachment must sit securely (see chapt
er „The Attach-
ments
– Application“).
2. Connect the mains adaptor with the motor unit and a wall socket.
3. Slide the ON/OFF-Switch (5) to the desired position. The
selected direction of rotation is shown by the coloured LED (4)
direction indicator as follows:
Green LED = Clockwise Rotation
Red LED = Counter Clockwise Rotation
