013
Operating your radio – FM
Insert the (supplied) external antenna plug into the external antenna
socket located on the rear of your radio.
Press the Power button to switch on your radio.
Press the Mode button to select the FM band.
Press and hold the Menu button to enter the FM menu.
Rotate the Tuning control knob to select “SCAN”. Press the Select
button to cause your radio to search from low frequency to high
frequency. When it finds a station of sufficient strength, the frequency
will flash 6 seconds on the display and the radio will continue to scan
after 6 seconds. To tune to the station or stop the scanning, press
the Select button.
The display will show the frequency of the signal found. If the signal
is strong enough and there is RDS data present then the radio will
display the station name.
When the end of the waveband is reached your radio will
recommence tuning from the opposite end of the waveband.
Press the Volume Up / Down button to adjust the sound level as
needed.
To switch off your radio, press the Power button.
1.
2.
3.
4.
5.
6.
7.
8.
9.
Summary of Contents for DDR-7
Page 1: ...Version 1 DDR 7 GB...
