Sangean DT-800, Manual

022

●  BEEP – Press the SELECT button, then the TUNING up or down 

button to select Beep ON or OFF during radio operation that requires 

press and hold buttons to activate e.g. enter MENU, memory preset 

stations etc. Press the SELECT button to confirm Beep setting.

●  LIGHT – Press the SELECT button then TUNING up or down button 

to select the display illumination time of 10S (seconds) -20S-30S-OFF 

after last radio operation. Select OFF if you do not want the display 

illuminated during radio operation to help extend battery life.

●

 ATS FM / ATS AM – see operation on ATS- Auto Tuning System described 

above. ATS FM / ATS AM can be operated only when the radio is on.

●

 AM 10K – AM tuning steps vary by countries. The AM tuning steps in 

Northern America and Latin America are 10 kHz / tuning steps while 

other countries are 9kHz. Press the SELECT button then TUNING up 

or down button to select either 10k or 9k AM tuning step. Press the 

SELECT button to confirm AM tuning step setting.

●  FM 100K – FM tuning step in Northern America and Latin America are 

normally 200kHz and 100kHz for other countries. Following the same 

procedures of selecting the AM tuning steps to select FM tuning step 

to be 50kHz, 100kHz or 200kHz.

● 87 – 108 – Select FM band frequency coverage.

FM band frequency coverage is normally 87.50-108 MHz for most 

countries; however for some countries like Japan and Russia, they 

may have various frequency coverage.

Following the same procedures as above to cycle through and set the 

required FM frequency coverage to be 87-108, 76-90, 76-108 or 64-

108 MHz.

Settings in MENU