Sangean H205D, Manual

7

   Manual Tuning- FM

. Press the Power button to switch on your radio.
. Press the Band button to select the FM band. Ensure your radio’s wire antenna is fully extended.
3. Press the Tuning Up/Down button.
4. Press either the Tuning Up/Down buttons to tune to a station. The frequency will change in steps of 50kHz. 
5. When the end of the waveband is reached the radio will recommence tuning from the opposite end of 
    the waveband.
6. Adjust the volume to the required setting.

   Display modes - FM

Your radio had a range of display options for FM mode.
. Press the Info button to cycle through the various options.

   a. Radio text

Displays scrolling text messages such as artist/track name, phone in number 
etc.

   b. Program Type

Displays the programme information for the station being listened to e.g. Pop, 
Classic, News, etc.

   c. Multiplex name

Displays the name of the FM multiplex to which the current stations belongs.

   d. Audio type

Displays the audio type for the currently tuned FM station.

   e. Time

Displays the current time.

   f . Date

Displays the current date

   g. Frequency

Displays the frequency of the station being listened to.

Note:

These FM mode information displays are only available when the radio is able to receive RDS 
information from the broadcaster.

   Scan sensitivity setting

Your radio will normally scan for FM broadcasts which are strong enough to give good reception. 

However, you may wish the search tuning function to be able to find weaker signals, possibly from more 

distant radio transmitters. Your radio includes a local/distant option for the search tuning function.
. Press and hold the Info/Menu button until the Advanced menu of FM mode shown on the display.
. Press the Tuning Up/Down button until ‘SCAN’ is displayed. Then press the Select button to enter the 
    setting menu.
3. Press the Tuning Up/Down button to select to scan either local or distant radio stations. The Distant 

    option will allow the radio to find weaker signals when scanning, whereas the Local option will scan 

    the strongest signals during scanning.

4. Press the Select button to confirm your setting. The Local or Distant setting is stored in the radio and 

    remains in force until changed or until a system reset.

Note:

The initial setting (out of the box, or after a System Reset) causes the radio to ignore weaker (or more 
distant) signals.