Sangean PR-D7, Instructions For Use Manual

9

  Manual tuning/station searching

1. Press the Power button to turn on the radio.

2. Select the required waveband by pressing the Band button.

    Adjust the antenna as described above.

3. A single press on either the Tuning Up or Down button will

    change the frequency in the following increments:

    FM: 50 or 100 kHz

    AM (MW): 9 or 10 kHz

4. Press and hold either Tuning Up or Down button until the

    frequency in the display begins to change rapidly.

    Release the button.

    Your radio will search the selected waveband and stop

    automatically when it finds a station of sufficient signal.

5. Rotate the Volume control to get required sound level.

6. To turn off the radio, press the Power button.

    Display will show off.

  Storing stations in preset memories

There are 5 memory presets for each waveband.

1. Press the Power button to turn on the radio.

2. Tune to a required station using one of the methods

    previously described.

3. Press and hold down the required preset until the radio beeps.

    The preset number will appear in the display and the station will

    be stored under chosen preset station.

4. Repeat this procedure for the remaining presets.

5. Stations stored in preset memories can be overwritten by

    following above procedures.