Sangean PR-D7, Instructions For Use Manual

7

  Using the supplied AC power adaptor

The supplied AC adaptor is 12 Volts DC output 500 mA center

pin positive.

1. Insert the adaptor plug into the DC IN socket on the left hand

    side of the radio.

2. Plug the adaptor into a standard 13A mains socket outlet.

    Whenever the adaptor is plugged into the radio and switched on

    the mains, the batteries are automatically disconnected.

If the adaptor is plugged into the radio but not the mains is not

switched on then the radio will run from the batteries if fitted.

The AC adaptor should be disconnected from the mains supply and

the radio when not is use.

Setting the clock

1. Clock can be set either the radio is power on or off.

2. Display will show “ - : - - “ when the batteries are installed when

    the radio is connected to the mains supply.

3. Press and hold the        button for more than 2 seconds,

    display will flash time set symbol        and also the hour digit,

    followed by a beep.

4. Press Tuning Up/Down to set required hour.

5. Press        button again, the minute digits will flash.

6. Press Tuning Up/Down to set required minute.

7. Press        button to complete time setting.