54
GB
FM Radio
Operating your radio in FM mode
. Carefully extend the wire antenna and press the
Standby
button to switch on your radio.
. Press the
Mode
button and press the Tuning buttons as needed to highlight FM radio mode.
Press the
Select button
to select the option.
3. Press and hold the Tuning up/down button to carry out an auto-tune. Your radio will scan in an
upwards direction (low frequency to high frequency)/or downwards direction (high frequency to
low frequency) and will stop scanning when it finds a station of sufficient strength.
4. The display will show the frequency of the signal which has been found. If RDS information is
available, after a few seconds the display will show the radio station name. If you only hear hiss
or interference, simply press and hold the Tuning up/down button to scan further. Your radio
may have found a spurious interference signal.
5. To find more FM stations, press and hold the Tuning up/down button to repeat the scan operation.
Or press the Select button to search for more available stations.
6. When the end of the waveband is reached your radio will recommence tuning from the opposite
end of the waveband. Use the volume button to adjust the sound level as needed.
Manual tuning
. Carefully extend the wire antenna and press the Standby button to switch on your radio.
. Press the
Mode
button and press the Tuning buttons
as needed to highlight FM radio mode.
Press the
Select button
to select the option.
3. Press the Tuning buttons to control the frequency that the radio will tune to. The frequency will
change in steps of 50kHz.When the end of the waveband is reached the radio will recommence
tuning from the opposite end of the waveband.
. Use the
Volume button
to adjust the sound level as needed.