74
GB
Headphone socket
A 3.5mm Headphone Socket located on the rear of your radio is provided for use with
headphones. Inserting a plug automatically mutes the internal loudspeaker.
Please be aware that the sensitivity of headphones can vary widely. We therefore recommend
setting volume to a low level before connecting headphones to the radio. It is also recommended
to reduce the volume before unplugging your headphones.
To prevent possible hearing damage, do not listen at high volume levels for long periods.
IMPORTANT:
Excessive sound pressure from earphones and headphones can cause hearing loss.
Auxiliary input socket
A 3.5mm Auxiliary Input socket located on the rear of your radio is provided for connecting the
audio signal from an external audio source such as an MP3 or CD player.
1. Connect a stereo lead from the headphone output of your MP3 or CD player to the Aux In socket
located on the left hand side of your radio. Typically this lead will have a 3.5mm stereo plug at
both ends.
. Switch on your radio.
. Press the
Mode
button press the Tuning buttons until 'AUX in' mode is shown on the display.
Press the
Select button
to select the option.
4. Press the 'play' on the connected audio device. If you are using its headphone output for the
connection, set its volume control to a level of somewhere between two-thirds and maximum
(the objective is to get a strong audio signal but without too much distortion). Then adjust the
volume on the radio as required.
Note:
if using an iPod as the sound source, you may need to set its output to maximum to get an
adequate audio signal level.
5. After use, disconnect your player in order to listen to your radio conventionally.