10
GB
F
E
FM range setting
The FM frequency Band tuning range can be different
depending on where in the world you live. It may be
necessary to adjust the FM range to allow the radio to
work properly.
1.
After the tuning step setting is completed, rotate the
Tuning control knob until the FM frequency range
shows on the display. Then press the Tuning control
button to enter the FM range setting.
2.
Rotate the Tuning control knob to select the desired FM
range and press the Tuning control button to confirm
the setting.
The available FM range is as following:
FM: 87.5-108 MHz (North America) (default) Your radio
is preset with this tuning range, no adjustments are
necessary if you live in North America.
FM: 76-90 MHz (for Japan)
FM: 64-108 MHz (for Eastern European countries and
Russia)
FM: 76-108 MHz (for some of China area and European
countries)
USB socket for iPhone / Smartphone
charging
Your radio has a USB socket which is intended only
for charging an iPhone, smartphone or similar devices.
Charge time may vary and in some cases may take longer
to charge than when using the manufacturers charging
unit supplied with the smart phone.
1.
The radio can charge your iPhone, smartphone or
similar devices when the radio is in power on or
standby mode, in FM / AM radio mode, Sound mode,
BT mode or AUX IN mode.
2.
Connect your smartphone to the USB charging socket
on the rear of your radio.
3.
Your iPhone or smartphone will begin to charge.
4.
Once your iPhone or smart phone has fully charged
remove the USB cable.
Charging mobile phones (for example) or other devices
may affect the listening quality when listening to the AM /
FM band.
NOTE
The charger may not supply power to some USB
devices.
When not using or after charging, remove the USB
cable.
Do not connect power source to USB port. Otherwise
there is a risk of fire. The USB port is only intended
for charging lower voltage device.
Do not insert a nail, wire, etc. into the USB power
supply port. Otherwise a circuit short may cause
smoke and fire.
Do not connect this USB socket with your PC
USB port, as it is highly possible that it may cause
breakdown of the units.
Never use the USB socket in rainy or moist conditions
to prevent moisture from entering the radio.
IMPORTANT
System reset
If your radio fails to operate correctly, or some digits
on the display are missing or incomplete carry out the
following procedure.
1.
When the radio is in power on or standby mode, press
and hold the Info / Menu button until you hear a beep
to enter the menu setting.
2.
Rotate the Tuning control knob until “FACTORY”
appears on the display. Press and release the Tuning
control button, the “RESET NO” will appear on the
display and “NO” will flash. Rotate the Tuning control
knob to select “NO” or “YES”. If you do not wish to
carry out a system reset, select “No” and then press
the Tuning control button. The display will revert back
to the previous display.
3.
To select “YES”, press and release the Tuning control
button. A full reset will be performed. All station presets
will be erased. Alarms will be cancelled and the sleep
timer settings will be set to their default values. All the
icons will show on the display and the radio will turn off
automatically. In case of malfunction due to electrostatic
discharge, reset the product (reconnection of the power
source may be required) to resume normal operation.
4.
You may also elect to unplug your radio for at least 12
hours to reset your radio.
