5
GB
Using the clock radio for the first time
1. Place your clock radio on a flat surface.
. Fully extend the wire aerial located on the rear of your
clock radio.
Place the wire antenna so that it is straight as possible
extending either above or below the radio.
. Insert the adaptor plug into the DC socket located on
the rear of your clock radio. Plug the adaptor into a
standard amp mains socket outlet. The display will
show "time zone" for a few seconds and then the display
will ask you to set your time zone. To set the time zone,
press the Tuning up/down button and the Select button
to confirm. The clock hands will then move to 12:00.
The radio will scan for signal and if a signal is found
and received completely it will then show the (xx xxxx
symbol) on the screen without flashing. Now the radio
will show both the current time and the clock hands
will then move to show the correct time.
Summary of Contents for RCR-9
Page 1: ...Version 1 GB RCR 9...
Page 3: ......
