11
EN
installation
gEnEral information
The washing machine can be installed in any
place on condition that:
• is protected from the bad weather;
• the ambient temperature is not lower than
3 ° C;
• the cables and hoses at the back of the
machine are not crushed;
• the power cord is accessible in case of
any maintenance.
n.b. should it prove necessary for electrical
and/or hydraulic maintenance contact only
a qualified technician.
rEmoval of transportation
locking scrEWs
N.B. Failure to removal the fixing screws will
generate strong vibrations and abnormal move-
ment of the machine during the washing with
consequent damages.
The washing unit is locked out by four fixing
screws (which protect it during transport) as
show in figure 1.
before operating the machine the screws
must be removed. to unscrew them use a
spanner.
Figure 1
once unscrewed the screws pull out the
locking screws including a bushing and
spacer as shown in figure 2.
Figure 2
n.b. in case the spacers fall into the machine
it will be necessary to open the rear panel,
retrieve them and reposition the panel.
close up the holes with the supplied caps
as shown in figure 3.
Figure 2b
positioning of WasHing
To ensure stability to washing machine and
avoid strong vibrations during washing and
spinning, it is necessary that the appliance
be placed on a smooth, hard, dry surface and
not raised above floor level. To compensate
for any unevenness in the floor it is possible
to act on the height of the feet, by screwing or
unscrewing them according to requirements.
As shown in the figure in the next page.
