8
Procedure to Clean the Foot Bath:
S
TEP
1:
Preparation,
Jet Removal, and Cleaning
•
Drain the
Footbath
according to draining procedure.
•
Rotate the
Jet Assemblies
counterclockwise and remove
them from the
Jet Cases
in the
Footbath.
•
Disassemble the
Jet Assemblies
(three pieces) for further
cleaning.
•
Spray the
Jet Assembly Pieces
,
Footbath Interior
,
and
Jet Cases
with *Cleaner / Disinfectant.
•
Use a clean cloth to clean the
Jet Assembly
pieces,
removing any visible soil.
•
Scrub all surfaces of the
Footbath
and
Jet Cases.
•
Rinse all surfaces with tap water
S
TEP
2:
Disinfection and Re-Assembly
•
Spray the
Jet Assembly
pieces,
Jet Cases
and
Foot Bath
until thoroughly wet with *Cleaner / Disinfectant
and allow them to set for 1 minute.
•
Rinse disinfectant from all surfaces.
•
Dry the
Jet Assembly
pieces,
Jet Cases,
and the
Footbath
, with a clean cloth.
•
Reassemble
Jet Assemblies
and reinsert them
into
Jet Cases,
rotate them in a clockwise manner to
secure them in position.
Detergent / Disinfectant Selection:
*SANIJET recommends the use of an EPA registered cleaner / disinfectant with tuberculocidal,
germicidal, pseudomonacidal, Fungicidal and Virucidal efficacy. Do not use abrasive cleaners on the
Pedicure Basin or Jet Assemblies. SANIJET suggests *DISPATCH
Hospital Cleaner Disinfectant with
Bleach as a suitable cleaner disinfectant for use with the above procedure.
Illustration #4
Removing Jet Assembly from
Jet Case
Illustration #5
Jet Assembly
Dispatch® - EPA Reg. No. 56392-7; EST. No.
62801-MI-001. Kills bacteria and viruses in 1 minute
and TB in 30 seconds.
