58
//59
3 –
Connect the electronic unit connector that leads to the solenoid
valve to the solenoid connector.
4 –
Connect the other electronic unit connector to the transformer
cable connector.
5 –
Before assembling the panel, consider using the provided adjusting
screw in order to optimize the operation of the mechanical button. If
needed, assemble the adjusting screw to the mechanical button at the
internal side of the panel and adjust it to the desired distance.
6 –
seat and Assemble the panel to the cover tighten it with the
bottom screw.
7 –
This product includes a self adjusting sensor. The ideal sensor
range for the specific location will be set automatically. Right now,
check that no objects are in front of the sensor.
8 –
Remove the protective sticker covering the sensor.
9 –
Plug in the transformer.
10 –
Wait about 30 seconds before you step or put your hand within
the sensor range. As an indication that the self adjusting is taking
place, a red light in the sensor eye will flash continuously. The solenoid
valve will be opened and closed for 1 second as an indication that the
ideal sensor range was set and the product is ready for use.
11 –
To operate, step within the sensor range for a minimum of 8
seconds. Move away and the flush valve will flush a few seconds after
your departure.
12 –
If needed adjust the flow rate by turning the regulating valve. In
order to avoid entering into the self adjusting mode, do not disconnect
the cables between the electronic unit and the transformer.
13 –
If the range is unsatisfactory, refer to the section entitled
“Settings Adjustment”.
8
6
7
//
INSTALLATION
