3
SAFETY WARNINGS
•
All personnel should be alerted to the potential hazards indicated by the product safety labeling on this fixture.
•
The following conventions are used to indicate and classify precautions in this manual and on product safety
labeling. Failure to observe precautions could result in injury to people or damage to property.
This is the safety alert symbol. It is used to
alert you to potential personal injury hazards.
Obey all safety messages that follow this
symbol to avoid possible injury or death.
Danger indicates an
IMMINENTLY
hazardous situation, which, if not avoided,
WILL
result in death or serious injury.
Warning indicates a
POTENTIALLY
hazardous situation, which, if not avoided,
COULD
result in death or serious injury.
Caution indicates a
POTENTIALLY
hazardous situation, which, if not avoided,
MAY
result in minor or moderate injury.
Caution used without the safety alert
symbol indicates a potentially hazardous
situation, which, if not avoided, may result
in property damage.
This symbol/pictorial is used to identify
an
ELECTRICAL SHOCK
or
ELECTROCUTION
hazard.
•
Product safety labels should be periodically inspected and cleaned, as necessary, to maintain good legibility.
Always replace illegible safety labels. Contact factory to obtain replacement safety labels.
This symbol/pictorial is used to identify
an
ULTRAVIOLET LIGHT
hazard.
This symbol/pictorial is used to identify
the need to wear approved ultraviolet
resistant face shield.
This symbol/pictorial is used to identify
the need to wear protective gloves.
!
SAFETY INSTRUCTIONS
WARNING
: To guard against injury, basic safety precautions should be observed, including the following:
1.
Read and follow
ALL
safety instructions.
WARNING
: Avoid exposure to direct or strongly reflected germicidal ultraviolet rays.
Germicidal ultraviolet rays are harmful to the eyes and skin.
2.
Intended for indoor use only.
3.
Do not alter the construction or design.
4.
Do not use this fixture for other than its intended purpose, as described in this manual.
5.
Do not override safety interlock.
6.
Do not remove any labels or devices.
7.
Do not mount under any source of moisture or condensation.
8.
CAUTION:
Do not operate without proper electrical ground.
9.
Do not operate the fixture if there is visible or suspected damage to the fixture or, if applicable, there is
damage to power cord and/or plug.
10. Keep inlet and outlet, of the blowers, clean and clear of debris.
11. Do not operate without access cover secured.
12. Stay clear of blowers, or other moving parts that can cause injuries.
13. Utility power supplied, to the fixture,
MUST
match power requirements listed on the fixture label.
14.
WARNING:
Always disconnect power to the fixture before performing any service or maintenance.
15. Read and follow all notices and warnings on the fixture.
16.
SAVE THESE INSTRUCTIONS
.
!
!
!
!