11
Handling
CAUTION
• Switch the device off and disconnect the power supply after every use and before every cleaning.
• Keep the device away from high temperatures.
• Never stand in the foot bath.
• The device must not be connected to the power supply while being filled.
• Always switch the foot bath off and remove the plug from the mains socket before moving it
or cleaning it.
5. Description of footbath
1
2
5
6
7
3
4
8
1. Splash protection
2. Function button
3. Fill-level mark
4. Bubble bar
5. Massage attachment
6. Rubber feet (on underside of device)
7. Foot rest with massage naps
8. Draining outlet
6. Initial use
• Before you plug in the foot bath, fill it up to the fill-level mark (approx 4 cm full) with either warm or
cold water. The foot rest should, however, be completely covered with water.
• Route the cable safely so that there is no risk of anyone tripping over it.
• Place the foot bath on a firm and level surface.
7. Use
In a comfortable sitting position, place your feet onto the massage-enhancing foot rest while applying
a gentle pressure. Rubber feet on the base of the device stop it from slipping.
Switch on the device. To do this, press the function button [2].
The vibration massage, bubble massage and water temperature control are started at the same time.
Massage attachment
The massage attachment in the middle provides a comfortable massage for your feet and stimulates
the circulation. This can be removed for cleaning purposes.
Note
• Massage of a specific point on the sole of the foot may influence the corresponding organ of
the body. However, we recommend studying relevant literature and asking your doctor before
using point reflex zone massage to achieve the desired effect.
