Sanitas SHK 30, Instructions For Use Manual

13

4.5 Automatic switch-off

This heating pad is equipped with an automatic switch-off function. This turns off the heat sup-

ply approx. 90 minutes after the initial use of the heating pad. The temperature setting display 

then starts to flash. So that the heating pad can be switched back on, the sliding switch for ON/

OFF and temperature settings (5) must first be set to setting “0” (OFF). After about 5 seconds 

it is possible to switch it on again.  

4.6 switching off

To switch the heating pad off, set the sliding switch for ON/OFF and temperature settings to setting “0” (OFF). 

The temperature settings are then no longer illuminated.

  NOTe:

If the heating pad is not in use, switch the sliding switch for ON/OFF and temperature settings to setting 

“0” (OFF) and unplug the mains plug from the socket. Then disconnect the controller from the heating 

pad by unplugging the plug-in coupling.

5. cleaning and maintenance

 WARNING

Before cleaning, always remove the mains plug from the socket first. Then disconnect the controller 

from the heating pad by unplugging the plug-in coupling. Otherwise there is a risk of electric shock.

 cAuTION

• The controller must never come into contact with water or other liquids, as this may cause damage.

To clean the controller, use a dry, lint-free cloth. Do not use any chemical or abrasive cleaning agents.

 cAuTION

• Please note that the heating pad may not be chemically cleaned, wrung out, tumble dried, put  

  through a mangle or ironed. Otherwise the heating pad may be damaged.

This heating pad is machine-washable. Set the washing machine to a particularly gentle wash cycle at 30°C 

(wool cycle). Use a delicate laundry detergent and measure it out according to the manufacturer’s instructions.

 cAuTION

• Please note that frequent washing of the heating pad has a negative effect on the product. The  

  heating pad should therefore be washed in a washing machine a maximum of 10 times during its  

 life.

Immediately after washing, reshape the heating pad to its original dimensions while it is still damp and spread 

it out flat on a clothes horse to dry.
 

 cAuTION

• Do not use pegs or similar items to attach the heating pad to the clothes horse. Otherwise the  

  heating pad may be damaged.

•  Do not reconnect the controller to the heating pad until the plug-in coupling and the heating pad are 

completely dry. Otherwise the heating pad may be damaged.

90

min

STOP